Dimension
Overall length: 520 mm · Overall height: 360 mm
2 × DimensionSize Labels
End-suction centrifugal pump annotation template
Pump example for pump and motor suppliers: overall length and height lines, plus a spec table with flow, head, power, voltage, speed, ports and IP rating.
Make it yours
Keep the layout. Add your photo and specifications.
Template overview
What this template includes
This centrifugal pump template has 3 annotations: overall length and height lines and a specification table. The values are examples, not measurements of your product.
Specification table
Specifications: Flow: 12 m³/h · Head: 32 m · Power: 2.2 kW
1 × Specification tableSpecifications
Example specifications
These are example values. Replace them with your product’s verified measurements and specifications.
Values shown in the image
- Overall length
- 520 mm
- Overall height
- 360 mm
- Flow
- 12 m³/h
- Head
- 32 m
Dimension2
| Annotation | Value |
|---|---|
| Overall length | 520 mm |
| Overall height | 360 mm |
Specification table1
| Annotation | Value |
|---|---|
| Specifications | |
| Flow | 12 m³/h |
| Head | 32 m |
| Power | 2.2 kW |
| Voltage / frequency | 380 V / 50 Hz / 3 ph |
| Speed | 2900 rpm |
| Inlet / outlet | DN50 / DN40 |
| Casing material | Cast iron HT200 |
| IP rating | IP55 |
| Insulation class | Class F |
Getting started
From this example to your product
- 01
Open the template
Start with this editable example in the SizeMarker editor.
- 02
Add your product photo
Replace the image and adjust the markers to fit your product.
- 03
Check and export
Enter your actual measurements and specifications, check every label, then export.
FAQ
Frequently asked questions
What does this end-suction centrifugal pump template show?
It marks 520 mm overall length and 360 mm overall height, and lists 12 m³/h flow, 32 m head, 2.2 kW, 380 V / 50 Hz three-phase, 2900 rpm, DN50 / DN40 ports, HT200 cast iron casing, IP55 and Class F insulation.
Can I use my own pump photo?
Yes. Open the template in SizeMarker, replace the photo, move the lines onto your pump and edit the values, labels and styles. Check every value against your product before exporting.
Can I use these values for my product?
No. Flow, head and electrical data are examples. Take duty point values from your pump curve, and only state an IP rating or insulation class your motor has been tested and certified for.
Make it yours
Use this template
Keep the layout. Add your photo and specifications.